3G W-CDMA 2100MHz Signal Booster Signal Repeater
NOTE:This product will be shipped with adapter plugs for the country of the buyer. Signal repeater installation diagram: How to install repeater (very easy and simple):
[===Not sure which Frequency your Phone Works ?===]
60 ±2 dB
60 ±2 dB
Ripple in Band
≤ -36 dBm
VSWR (Voltage Standing Wave Ratio)
MTBF (Mean Time Between Failure)
AC:100~240V, 50/ 60Hz;DC:5V 1A
< 5 W
Dimensions (D*W*H )
-10°C ~ 55°C
300x120x100mm(L x W x D)
1* 5dB outdoor antenna
1* 3dB indoor antenna
1* RG6-50 OHM outdoor Coaxial Cable-10m
1* mounting accessories
1*AC power supply(European)
Step 1: Use your mobile phone to test signal strength outside house or on roof, -70dbm is the basic requirement (full bar).
Step 2: Install outdoor antenna in that location and keep adjusting, point it to signal tower station, try to get the best signal.
Step 3: Run outdoor coaxial cable into building in a convenient location to connect with signal repeater.
step 4: Mount your indoor antenna with signal repeater
step 5: Power up signal repeater device to check the signal inside, moving outdoor antenna until you get a satisfied signal. Note:
Connect outdoor (BTS) port with outdoor antenna, connect indoor ANT(MS) port with indoor antenna, outdoor antenna is mounted at a higher position. Both antennas should be 10 meters far away from each other at least.
Indoor and outdoor antenna must be separated by wall. Signal problem & installation technique support:
1.If signal still weak after installation, please check if outdoor antenna point to signal tower correctly or elsewhere has stronger
signal and confirm signal strength achieve-70DBM.
2.If still have no signal after installation, please check our device power adapter whether connected perfectly.
3. If strength is not steady, please check if outdoor and indoor antenna is too close; please ensure outdoor antenna has distance of
10 meters at least, with a barrier and not in a same horizontal line.
4. Packed the outdoor connector by waterproof glue, otherwise the wet will reduce the signal cover area.